D-Link DIR-608 - Page 60

56D-Link DIR-608 User Manual
Section 3 - Conguration
WPS Setup
PIN of the router: The WPS PIN will be displayed here.
Enable WPS: Check the box to enable WPS.
Disable PIN: Check to disable WPS PIN.
Keep current
configuration:
Check to keep the current conguration.
WPS Setup
PIN of the router :
Enable WPS :
☑
Disable PIN :
☑
Keep current conguration :
☑
Access Control List
Click the ACL Setup button to edit the ACL (Access Control List). This takes you to the screen
below.
Enable Wireless
Access Control
Mode:
Check the box to enable Wireless Access Control Mode. In this mode,
only listed wireless devices will be allowed to connect to the wireless
network.
Click the Apply button when you are done.
Access Control List
ACL Setup
Wireless Access Control Mode
☐ Enable Wireless Access Control Mode
MAC Address Select
00e086710502
Add Cancel
Delete Selected Delete AllApply
MAC Address:
(ex: 00e086710502)
Advanced Wireless (continued)
When you have nished conguring your wireless network, click the Apply Changes button.
Apply Changes
MAC Address: Enter the MAC address of a device you wish to allow access for to
the WLAN and click the Add button. This will add the device’s MAC
Address to the ACL table above. To remove a device from the ACL
table, select the MAC address from the above table and click the
Delete button
If you enabled Wireless Access Control, you may begin adding MAC addresses to the ACL list.