D-Link DIR-608 - Page 63

59D-Link DIR-608 User Manual
Section 3 - Conguration
Wireless Security Settings
Wireless Repeater
DIR-608
Wireless
Advanced
Step 2: The page will refresh prompting you to input the wireless security key of the host
network. If the host network does not have wireless security enabled, this step is omitted.
Step 3: Enter a new LAN IP address for the DIR-608 if necessary.
Click Finish to complete the setup. You will need to reconnect to the wireless network the
DIR-608 is now repeating.
Wireless Repeater Setup (continued)
Wireless Security Settings
Enryption:
WPA2-PSK(TKIP)
▼
Security Options
Security Options: The host network’s wireless security encryption type is listed here. It
is not changeable.
Security Options(WPA-PSK)
Pre-Shared Key:
(8-63 characters or 64 hex digits)
Security Options(WPA2-PSK)
Pre-Shared Key: Enter the host network’s wireless security key.
When you have entered the wireless network’s key, click the Next button.
Previous Next
WPS Setup
Step 3: click ‘Finish’ to save the conguration.
We strongly recommend that you modify IP address of the
local gateway to avoid IP address conicts with the center
of the AP. (ex. if IP address of AP is 192.168.1.1, you can
modify IP address of the local gateway to 192.168.1.2)
IP Address:
192.168.11.1
Subnet Mask:
255.255.255.0
Finish