D-Link DIR-615+ - Page 58

54D-Link DIR-615+ User Manual
Section 4 - Conguration
L2TP (cont)
Miscellaneous
NAT: Toggle this switch to enable Network Address Translation (NAT). This
setting is enabled by default.
Firewall: Toggle this switch to enable rewall functionality. This setting is
enabled by default.
RIP: Toggle this switch to enable Routing Information Protocol (RIP). This
setting is disabled by default.
Ping: Toggle this switch to enable WAN Ping. This setting is disabled by
default.
Isolate
connection:
Toggle this switch to enable connection isolation. This setting is
disabled by default.
Click Apply when you are done.