88D-Link DIR-615+ User Manual
Section 4 - Conguration
Remote Access
Remote access allows you to access the web GUI from WAN. By default, the
access from external networks to the router is disabled for security reasons. If
you need to allow access to the router from external networks, create relevant
rules.
Remote Access
Add: Click here to add a new rule, described below.
Delete: Click here to delete a selected rule.
IP address: Indicates the IP address permitted to access the GUI.
Mask: Indicates the subnet mask of the IP address permitted to access the
GUI.
Public Port: Indicates the public port over which the IP address is permitted to
access the GUI.
Protocol: Indicates the protocol used to access the GUI.
Add Rule
Open access: Toggle this switch to enable any remote host to access the GUI. This
is not recommended.
IP address: Specify the IP address of the remote host allowed to access the GUI.
Mask: Specify the subnet mask of the remote host allowed to access the GUI.
To Next Page
Loading...
