Web Configuration
D-Link DSL-2600U User Manual 14
Quick Setup
The Quick Setup page mainly includes the following three functions:
= WAN interface setup
= LAN interface setup
= Wireless interface setup
Quick setup enables fast and accurate configuration of your Internet connection and other important parameters. The following sections describe these various
configuration parameters. Whether you configure these parameters or use the default ones, click Next to enable your Internet connection.
When subscribing to a broadband service, you should be aware of the method by which you are connected to the Internet. Your physical WAN device can be Ethernet,
DSL, or both. Technical information regarding the properties of your Internet connection should be provided by your Internet service provider (ISP). For example, your ISP
should inform you whether you are connected to the Internet by using a static or dynamic IP address, or the protocols, such as PPPOA or PPPoE, which you use to
communicate over the Internet.
WAN Interface Setup
During WAN interface setup, you can set up a PVC and its properties:
= VPI
= VCI
= QoS
= Internet connection type
= Encapsulation type
= IGMP service
= NAT
Setting Up VPI/VCI and QoS
After logging in to the DSL router, if no PVC is configured previously and no default settings
exist, the Quick Setup webpage appears, which contains some basic configuration that is
needed by ATM PVC. The following introduction guides you through the necessary steps to
configure your DSL Router.
To Next Page
Loading...
Need help?
Power
Data Transfer Rates
