D-Link DSL-2600U User Guide

Web Configuration
D-Link DSL-2600U User Manual
22
Step 3 Click Next and the WAN IP configuration page appears.
You can select the service function as follows:
= Use the following IP address (static wan ip)
= Use the following default gateway (static gateway ip)
= Use the following DNS server addresses (static DNS server ip)
Step 4 Click Next and the IPoA IGMP and WAN function configuration page appears.
To use IGMP service on ipoa pvc, select the Enable IGMP Multicast check box.
In the MER mode, you can configure the following functions:
= Enable NAT.
= Enable Fullcone NAT.
= Enable Firewall.
Internet Connection Type – Bridging
Step 1 In the PVC and its QoS configuration page, configure a PVC and its QoS.

D-Link DSL-2600U Specifications

Power

input voltage	100V-240V
input current	0.6A
input frequency	50 Hz - 60 Hz
output voltage	12V
output current	1A

Data Transfer Rates

G.dmt full rate downstream	up to 8 Mbps
G.dmt full rate upstream	up to 1 Mbps
G.lite ADSL downstream	up to 1.5 Mbps
G.lite ADSL upstream	up to 512 Kbps
G.dmt.bis full rate downstream	up to 12 Mbps
G.dmt.bis full rate upstream	up to 1 Mbps
ADSL2+ full rate downstream	up to 24 Mbps
ADSL2+ full rate upstream	up to 1 Mbps
IEEE 802.11b wireless transfer rates	11, 5.5, 2, and 1Mbps
IEEE 802.11g wireless transfer rates	6, 9, 12, 18, 24, 36, 48, 54 Mbps

Interfaces

ADSL interface connector	RJ-11
LAN interface port	RJ-45
LAN interface standard	10/100BASE-T Ethernet