D-Link DSL-2700U - Page 19

The following table describes the labels in this screen.
LABEL
DESCRIPTION
Username Enter your username here.
Password
Enter your password here.
VPI Enter the VPI here. VPI can range from 0 to 255.
VCI Enter the VCI here. VCI can range from 1 to 65535.
Connection Type Select your connection type from the dropdown list.
Your ISP should provide the above information. Note that you must
enter the user name exactly as your ISP assigned it. If the assigned
name is in the form of user@domain where domain identifies a
service name, enter it exactly as given. Click on Back to return to
the previous screen, Next to continue, or Cancel to exit the wizard
without saving.
4. Bridge Mode
RFC 1483 explains two methods for Multiprotocol Encapsulation
over AAL5. The first method allows multiplexing of multiple
protocols over just one ATM virtual circuit (LLC-based multiplexing).
The second method assumes that each individual protocol is
carried over a separate ATM virtual circuit (VC-based multiplexing).
Please refer to RFC 1483 for more information.
The following table describes the labels in this screen.
LABEL DESCRIPTION
VPI
Enter the VPI here. VPI can range from 0 to 255.
VCI
Enter the VCI here. VCI can range from 32 to 65535.
Connection Type
Select your connection type from the dropdown list.
Your ISP should provide the above information. Click on Back to return
14