D-Link DWR-933 - Add IP Filter

42D-Link DWR-933 User Manual
Section 3 - Conguration
If you selected Add New IP Filter:
Add IP Filter
Protocol
Source IP
Subnet
Source Port Number
Source Port Range
Dest IP
Destination Port
Number
Destination Port Range
Select the protocol for ports that you want to allow or
deny access to. Choose between TC P, UDP or ICMP
or all of the above.
Enter the source IP address that you wish to lter.
Enter the subnet mask of the source IP address you
wish to lter.
Enable this feature if you wish enter a single port or a
range of ports to be ltered based on origin. Disabling
this feature will cause all incoming connection tting
other criteria to be ltered.
Enter an incoming port range to which your lter will
apply.
Type in the destination IP address. Leave this blank
to apply your lter to incoming connections to any
destination IP
Click the toggle if you wish enter a single port or a
range of ports to be ltered. Separate port numbers
with a comma.
Enter a destination port range to which your lter
will apply.