When the combine begins to
enter or leave the transport-
ing truck bed, the combine
will change its pose abruptly.
You should slow down.
(A) Tilt abruptly
When transporting the com-
bine, rope the combine’s
rope hooks to the transport-
ing vehicle. And hold the
parking brake lever.
(1) Rope Hooks
( 2 front and 2 rear hooks)
•
•
1. When loading onto or unload-
ing the combine from a vehicle,
use ramps that ar e str ong ,
wide (at least 1.2 times wide as
the width of the crawler), and
long (4 times long as the height
of the cargo bed of the vehicle)
enough and are not slippery or
exible.
(A) 4 times long as the height of the cargo
bed of the vehicle
(B) Height of the cargo bed
2. Ensure the ramps are straightly
lined up with the cargo bed of
the transporting vehicle and
the hooks on the ramps are
securely engaged to the cargo
bed without any bumps.
3. Never attempt to change the
combine’s direction or speed
on th e ramps. If do so, th e
combine may change its direc-
tion abruptly and fall down.
4. Do no t a ll ow peop le to a p
-
proach near the combine.
LOADING /UNLOADING THE COMBINE
417O612A
CAUTION
417O613A
1. Perform load/unloading the
combine on a at ground with
a helper’s guidance. Don’t let
people stand around the com-
bine.
CAUTION
417O614A
417O615A
CAUTION
To Next Page
Loading...
Need help?
General
