THE BUZZER BEEPS AND THE ENGINE STOPS
Reference
Troubleshooting
Check if any conveying part (the feeding chain,
straw discharge chain, or inlet of the straw cut-
ter) is clogged with straw debris.
To remove the debris, open the threshing unit
compartment cover.
Check if the cutter is sharp. If it is dull, sharpen
or replace it with a new one.
Cause
The straw con-
veying chain is
clogged
The straw cutter
is blocked
Checking point
Conveying
parts
Cutter
Immediate actions
The straw
discharge
lamp is
ickering
Stop reaping and check the
alertlamps
Disengage the reaping and
threshing clutch levers
BLOCKED THRESHING CYLINDER
ReferenceTroubleshooting
1. Switch off the engine
2. Make sure that the power supply to the
threshing component has been cut off.
3. Open the cover of the threshing cylinder
4. Dismantle by loosening the fastening bolt
of the cutter
5. Open the threshing cylinder
6. Dismantle the cutter
7. To dismantle the concave sieve, rotate the
upper portion of the threshing cylinder.
Cause
Blocked by
damp crops or
foreign objects.
Checking point
Overheating
Immediate actions
Turn the main switch to a stop position.
(Switch off the engine)
To Next Page
Loading...
