(1) Reaping Blade (
)
417O839A
CUTTER
1. Shut off the engine after the cut-
ter is raised. Evenly add oil to
each position of the cutter after
anti-falling tools are installed.
2. After oil is added, start the en-
gine and then stop the engine
after the cutter runs for 30 sec-
onds.
3. Dismantle the anti-falling tools
and lower the reaping unit.
ROUTINE INSPECTIONS
AND ADJUSTMENTS
Before checking or adjust-
ing each part, shut off the
Shut off the engine before
checking the oil and coolant
levels, oiling parts, or han-
dling the battery.
The reaping unit may fall
down after being raised up
for a long time. Pay close
attention to it.
•
•
•
SAFETY RULES
To Next Page
Loading...
