1. Insert the sorting seal 1
over the 1
st
flow plate by
pushing down the seal dur-
ing the insertion.
2. Pla c e the 2
nd
seal in the
middle of the 2
nd
3. Ope n the thre shing unit
cover and remove its sup-
port and assemble the side
seals as shown in the fol-
(1) 2 Sieve Case Front Seals
(2) 2 1st Flow Plate Seals
(3) 2 2nd Flow Plate Seals
(4) Oscillator Axle Seal
(5) Fuel Tank
(6) 2 Side Seals on Each Side
417O812A
CAUTION
4. Fasten the assembly bolts
of the oscillator axle stand.
5. Install the oscillating drive
belt and lock the tension le-
ver.
6. Fix the oscillator seal over
the rear of the fuel tank.
7. After installing the thresh
-
ing sieve, fix the threshing
rotor.
8. Failure to properly locate all
of the seals as shown in the
figure, grain loss and poor
separation will happen. Ad-
just them as shown in the
CAUTION
(1) Cutter (2) Supporting Pins
417O813A
STRAW CUTTER
INSTALLING THE CUTTER
1. Lifting and attaching the straw
cutter should be done by at
least 2 or more people.
(The cutter should be placed on
the supporting pins on the com-
bine.)
Shut off the engine before
servicing the straw cutter.
•
CAUTION
To Next Page
Loading...
Need help?
General
