417O605A
417O604A
(1) Main Switch
1. Warn bystanders of starting the
engine and check their safety.
2. Put the key into the main switch
hole and turn the key to START.
If the engine’s temperature is
below-5ºC, turn the key to PRE-
HEAT and wait 10-30 seconds.
3. When the engine starts, release
the key.
(1) Main Shift Lever
(2) Aux. Shift Lever
(3) Threshing Clutch Lever
(4) Reaping Clutch Lever
(A) Disengage
STOP THE ENGINE
After disengaging the reaping and
threshing clutches, turn the key to
OFF and take out the key. (Only
turning the key to OFF will shut off
the engine.)
When the key switch can not
stop the engine, the engine can
be forced to shut off by pulling
out the engine shut-off knob.
Sh a rp tur n in g at a h i gh
speed is very dangerous.
Before the turn, reduce your
speed first. Then, slowly
move your steering lever.
When entering into a field,
drive down slowly and ver-
tically from a field bank or
levee.
If the bank or levee is 10
cm or higher, you must use
ramps to get into the eld.
Before crossing a railroad
track, always look both ways
and listen carefully to be
sure a train is not coming
from either direction. If safe,
cross the track quickly.
•
•
•
CAUTION
DRIVING ON ROADS
E32O408A
Start
Off
On
Preheat