DAELIM NS125III

Transmission/Crankshaft/Crank Case
Transmission
● Loosen the drain bolt and remove the transmission oil.
● Remove R. crank case cover. (󳫻 section 8)
● Remove the continuously variable transmission
(󳫻 section 7)
● Remove the rear wheel (󳫻 section 13)
● Loosen the 8 transmission cover bolts.
● Remove the transmission cover.
● Remove the gasket and dowel pin.
● Remove the drive shaft from the transmission
cover by using a hydraulic press.
NOTE
● Remove the oil seal of the drive shaft.
11-3
󳢯Take precautions not to damage the cover joints.
Transmission
oil drain bolt
Transmission cover
Drive shaft
Transmission cover
Oil seal
Dowel pin