DAELIM NS125III

Ingnition Coil
Generator connector
Ignition System
Ignition Coil Inspection
● Remove the luggage box. (󳫻 4-5)
● Remove the body cover. (󳫻 4-6)
● Remove the center cover. (󳫻 4-4)
● Remove the primary wire.
NOTE
● Measure the primary resistance between the
ignition coil terminal and earth.
Standard value: 0.1-0.2
ΩΩ
● Remove the spark plug cap from the plug.
● Measure the secondary resistance between the
ignition coil spark plug cap and earth.
Standard value: 7.3-11K
ΩΩ
● If the measured value deviates from the
prescribed value, remove the plug cap from the
high-tension cord, and measure the secondary
resistance.
Standard value: 3.6-4.6K
ΩΩ
Replacement
● Remove the high-tension cord from plugs and
clamps. Remove the primary wire from the
ignition coil. Loosen 2 bolts to disassemble the
ignition coil.
● Install in the reverse order of removal.
16-4
󳢯 This test is inaccurate. Conduct the ignition coil
performance test with an ignition coil tester.
Ingnition Coil
Generator connector