Operation Section
-98-
Transportation Hints
Lift Truck Shipping
Check travel route for overpass clearances. Make sure
there is adequate clearance if the lift truck being
transported is equipped with a high mast, overhead
guard or cab.
To prevent the lift truck from slipping while loading, or
shifting in transit, remove ice, snow or other slippery
material from the loading dock and the truck bed before
loading.
NOTICE
Obey all state and local laws governing the height,
weight, width and length of a load.
Observe all regulations governing wide loads.
NOTICE
Remove ice, snow or other slippery material from the
shipping vehicle and the loading dock.
Always block the trailer or the rail car wheels before
loading the lift truck.
Position the lift truck on the truck bed or the rail car.
Apply the parking brake and place the transmission
control in NEUTRAL.
Turn the ignition switch to the OFF position and remove
the key. If LP-Gas equipped, shut off the LP-Gas fuel
tank.
Block the wheels and secure the lift truck with tiedowns.
Machine Lifting and Tiedown
Information
NOTICE
Improper lifting or tiedowns can allow load to shift and
cause injury and/or damage.
1. Weight and instructions given herein apply to lift
trucks as manufactured by DOOSAN.
2. Use proper rated cables and slings for lifting.
Position the crane for level lift truck lift.
3. Spreader bar widths should be sufficient to prevent
contact with the lift truck.
4. Use the tiedown locations provided for lift truck
tiedown.
Check the state and local laws governing weight, width
and length of a load.
Contact your DOOSAN Lift Truck dealer for shipping
instructions for your lift truck.
To Next Page
Loading...
Need help?
General
