Maintenance Section
-152-
Fuel Lines & Fittings - Check
Visually inspect fuel lines and fittings for physical
damage. Replace as required.
Inspect Mixer Assembly (G643E
Engine Only)
Refer to the LP mixer section of the engine service
manual for procedures.
Inspect Throttle Assembly (G643E
Engine Only)
1. Visually inspect the throttle assembly motor housing
for coking, cracks and missing cover-retaining clips.
Repair and/or replace as necessary.
NOTE: Refer to the LP mixer and throttle section of the
service manual for procedures on removing the
mixer and inspecting the throttle plate.
Hydraulic Return Filter - Change
See topic “Hydraulic Return Filter - Change” in “First 250
Service Hours or a Month”.
Air Breather - Change
Park the lift trucks level, with the forks lowered, parking
brake engaged, transmission in NEUTRAL and the
engine stopped.
1. Raise the hood and seat assembly.
2. Remove and discard the air breather.
3. Install a new air breather.
4. Lower the hood and seat assembly.
Transmission Oil, Oil Filter & Strainer
- Clean, Change
See topic, “Transmission Oil, Oil Filter & Strainer - Clean,
Change” in “First 50 - 100 Service Hours or a Week”.
To Next Page
Loading...
Need help?
General
