Maintenance Section
-150-
Every 1000 Service Hours or 6 Months
You must read and understand the warnings and instructions contained in the Safety section of this manual, before
performing any operation or maintenance procedures.
Carburetor (LP - Gas Engine Only) -
Adjust, Clean
If the engine is hard to start or the exhaust is smoking,
the carburetor may need cleaning and adjusting.
Before adjusting the carburetor make sure the engine is
at normal operating temperature. Park the lift truck with
the forks lowered, parking brake applied, transmission in
neutral and the engine stopped.
For the complete procedure and specifications for your
specific engine, see the “Service Manual”.
Fuel Filters - Change
Diesel Engine
Park the lift truck with the forks lowered, parking brake
applied, transmission in neutral, engine stopped and
cool.
1. Raise the hood and seat assembly. Make sure the
hood support latch is engaged in the bracket.
WARNING
Fuel leaked or spilled onto hot surfaces or electrical
components can cause a fire.
Turn the disconnect switch OFF or disconnect the
battery when changing fuel filters.
2. Loosen the plug (1) and remove cartridge (12) from
head.
3. Fill up clean fuel to the new cartridge.
4. Replace the rubber packing and smear clean fuel to
the rubber packing.
5. Install new cartridge and remove an air in the filter
with a feed pump.
To Next Page
Loading...
Need help?
General
