Operation Section
-67-
After Starting the Engine
Observe all indicator lights and gauges frequently during
operation, to make sure all systems are working
properly. All of the indicator lights will come ON with the
ignition switch in the ON position before the engine is
started.
Diesel (24V)
LPG (12V)
1. The engine oil pressure indicator light (1), will
not come ON with the engine running, unless
there is low or no oil pressure. Stop the engine
immediately, if the light comes ON.
2. The alternator indicator light (2), should not
come ON during normal operation. The
alternator is not charging if the light comes ON
with the engine running.
3. The G643E engine MIL (Malfunction
Indicator Light)(3) will not come ON with engine
running, unless the fault or faults are stored in
the memory of the engine control module (ECM). Stop
the engine and check the electric engine control system if
the light comes ON. Refer G643E Engine of this section.
4. Observe the diesel fuel level gauge (4) for fuel
level in the tank.(Diesel Engine Only)
5. The engine coolant temperature gauge pointer
(5), will be in the green band with the engine
running, unless the coolant temperature is
excessive.
6. The power shift transmission oil temperature
gauge pointer (6), will be in the green band with
the engine running, unless the oil temperature is
excessive.
7. Observe the hour meter (7) to make sure it is operating
properly.
To Next Page
Loading...
Need help?
General
