Operation Section
-66-
LP-Gas Engine
WARNING
LP - Gas fuel is flammable and can cause personal
injury.
Inspect LP - Gas fuel lines and fitting for leaks.
Inspect tank for secure mounting.
1. Open the tank fuel valve by slowly turning the valve
counterclockwise. Observe the LP-Gas gauge(if
equipped).
2. Turn the engine ignition switch to the START
postion. Release it when the engine starts.
3. If the engine does not start, do not press on the
accelerator pedal. Turn the starter switch to OFF
position, then repeat step 2 and depress the
accelerator pedal slightly during cranking.
4. Allow the engine to warm up slowly.
Starting From a 12 Volt External
Source
WARNING
Sparks occurring near the battery could cause
vapors to explode.
Always connect the external power source ground
cable to a point away from and below the battery,
and well clear of fuel system components.
NOTICE
Do not reverse battery cables. It can cause damage
to the alternator.
Always connect the external power source cables in
parallel with the lift truck battery cables :
POSITIVE(+) to POSITIVE(+) and NEGATIVE(-) to
NEGATIVE(-).
Attach ground cable last, remove first. All lift trucks
equipped with DOOSAN built internal combustion
engines are NEGATIVE(-) ground.
To Next Page
Loading...
Need help?
General
