General Section
-49-
Operator's Warning and Identification Plate
Familiarize yourself with the OPERATOR'S WARNING Plate, and IDENTIFICATION, LIFT CAPACITY and
ATTACHMENT PLATES. DO NOT exceed capacity as equipped load ratings
.
Operator’s Warning Plate
Located on the cowl to the right side of the steering
column.
Identification, Lift Capacity and
Attachment Plate
Located on the cowl to the right side of the steering
column.
Lift Truck Capacity Rating
DO NOT exceed allowable lift truck working capacity
load ratings.
The capacity of the lift truck is given by weight and
distance to the load center. For example, a capacity of
1200kg (2640lb) at 600mm (24in) means that the lift
truck can lift 1200kg (2640lb) if the load center is 600
mm (24in) from both the vertical and horizontal faces of
the forks.
Before attempting to lift any load, ensure that the weight
and load center combination is within the capacity of the
lift truck as shown on the capacity rating plate. To
determine the load center, measure the distance from
the face of the carriage to the gravitational center of the
load.
The rated capacity on the plate refers to the capacity of
the lift truck as it left the factory. Subsequent changes of
any form to the equipment or battery can alter the lift
truck’s rating.
The rated capacity of the lift truck applies to operating
conditions where the lift truck is on level ground. The
capacity of the lift truck is reduced on inclines.
Below are abbreviations that may appear on the
Identification, Lift Capacity and Attachment Plate and
their meanings.
To Next Page
Loading...
Need help?
General
