Safety Section
-24-
Do not raise anyone on the forks of your lift truck unless
using an approved safety cage.
Do not let other people ride on the truck.
Lift trucks are designed to carry loads, not people.
Do not operate your truck without the load backrest
extension and overhead guard. Keep the load against
the backrest with the mast tilted backward.
Do not lift or move loads that are not safe. Do not pick
up an off center load. Such a load increases the
possibility of a tipover to the side. Make sure loads are
correctly stacked and positioned across both forks.
Always use the proper size pallet. Position the forks as
wide as possible under the load. Position loads evenly
on the forks for proper balance. Do not lift a load with
one fork.
Do not overload. Always handle loads within the rated
capacity shown on the capacity plate.
Do not add extra counterweight to the truck.
An overload can cause the truck to roll over and cause
injury to personnel and damage to the lift truck.
Do not drive on soft ground.
Observe all signs, especially those on maximum
permitted floor loadings, elevator capacities and
clearance heights.
Handle loads carefully and check them closely for
stability and balance.
Do not drive on slippery surfaces.
Sand, gravel, ice or mud can cause a tipover. If
unavoidable, slow down.
To Next Page
Loading...
Need help?
General
