Press OFF to enable SSH (optional). After SSH is enabled, the debugging terminal
connects VTH through SSH protocol, so as to operate and debug it.
Press OK to save the configuration.
4.2.4 Configure SIP Server
Configure SIP server on VTH and build connections.
Press and hold Setting until the system displays the Password Verification dialog box.
Type your password and press OK.
Press SIP Server.
Set the parameters for the SIP server using the following information.
Server IP
This IP Address is either:
• the IP Address of the separate SIP server.
• the IP address of the VTO, if the VTO is acting as the SIP
server.
Network Port
Standalone SIP server: network port is 5080.
VTO as SIP server: network port is 5060.
User Name
Use default value.
Register Pwd
Domain
Registration domain of the SIP server. This value can be left blank.
If the VTO is the SIP server, use VDP as the domain
User Name
User name and password to login to the SIP server.
Login Pwd
Table 4-1: SIP Server Parameters
To Next Page
Loading...
Need help?
General
