Set the following parameters:
Monitor Time
Maximum time to monitor the video from a VTO, VTO sub-
station, IP camera or another device.
Record Time
Maximum recording time of videos during call, talk,
monitoring, and speaking. The system stops recording at
the end of recording time.
VTO Message
Time
• When VTO message time is not 0:
• If VTH with SD card doesn’t answer when VTO calls,
enter message status according to prompt, and save the
message in SD card of VTH.
• If VTH doesn’t have SD card, but VTO has enabled
“Leave Message Upload” and set FTP server, “Message”
tab will appear at VTH info interface. If VTH doesn’t
answer when VTO calls, enter message status according
to prompt, and upload the message to FTP server.
• If VTH doesn’t have SD card, and VTO has not enabled
“Leave Message Upload”, if VTH doesn’t answer when
VTO calls, hang up automatically.
• When VTO message time is 0:
• Hang up automatically if VTH doesn’t answer when VTO
calls, no matter whether VTH has SD card or not, no
matter whether VTO has enabled “Leave Message
Upload” or not.
If VTO sets to forward the call to management center, if
VTH doesn’t answer when VTO calls, and there is no
message prompt, the call will be forwarded to management
center.
Resident-to-
resident Call
Time
Maximum talk time between VTH and another VTH.
VTO Talk Time Maximum talk time when a VTO calls a VTH.
Resident-to-
resident Call
Enable
After resident-to-resident call is enabled, VTH can call
another VTH.
The called party enables internal call, to realize this
function.
Auto Capture
After auto capture is enabled, 3 pictures will be captured
automatically when VTO calls VTH. View them at “Info >
Record and Picture” interface.
This function is valid only when SD card is inserted.
Touch Ring
After enabling touch ring, there will be a ring when touching
the screen.
Table 5-4: Other VTH Setting Parameters
To Next Page
Loading...
Need help?
General
