System can pop up a message to alarm you in the local
host screen if you enabled this function.
Check the box here to enable this function. The buzzer
beeps when an alarm occurs.
System can upload the alarm signal to the centre
(Including alarm centre.
If you enabled this function, System can send out an email
to alert you when an alarm occurs.
Here you can set PTZ movement when alarm occurs.
Such as go to preset X.
5.9.3.2.2 Net Alarm
The network alarm interface is shown as in Figure 5-35.
Network alarm refers to the alarm signal from the network. System does not support anti-dither
and sensor type setup. For reset setups, please refer to chapter 5.9.3.2.1.
Figure 5-35
5.9.3.2.3 Alarm Out
Here you can set alarm output channel mode: schedule/manual/stop. See Figure 5-36.
Figure 5-36
To Next Page
Loading...
