Figure 4-28
4.8.3 G-Sensor
The G-Sensor interface is shown as in Figure 4-29. Here you can set device orientation and
sensitivity.
Figure 4-29
4.8.4 Register
This function allows the device to auto register to the proxy you specified. In this way, you can use
the client-end to access the DVR and etc via the proxy. Here the proxy has a switch function. In
the network service, device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the
To Next Page
Loading...
