The abnormal events include: No disk, disk error, disk no space, battery
low, temperature high.
You can set one or more items here.
Check the box here to enable selected function.
Please select corresponding alarm output channel when an alarm
occurs. You need to check the box to enable this function.
The alarm output can delay for the specified time after an alarm stops.
The value ranges from 1s to 300s.
System can pop up a message to alarm you in the local host screen if
you enabled this function.
System can upload the alarm signal to the centre (Including alarm
centre.
If you enabled this function, System can send out an email to alert you
when an alarm occurs.
Check the box here to enable this function. The buzzer beeps when
an alarm occurs.
5.9.7.7 Display
Display interface includes GUI, and TV adjust.
5.9.7.7.1 GUI
Here you can set background color and transparency level. See Figure 5-69.
Figure 5-69
Please refer to the following sheet for detailed information.
There are five options: 1920×1080, 1280×1024, 1280×720,
1024×768, 800×600(Default). Please note the system needs to
reboot to activate current setup.
Here is for you to adjust transparency. The value ranges from 128
to 255.
To Next Page
Loading...
