Please refer to the following sheet for detailed information.
Select speed dome connected channel.
Select the corresponding dome protocol such as PELCOD.
Set corresponding dome address. Default value is 1. Please note
your setup here shall comply with your dome address; otherwise
you can not control the speed dome.
Select the dome baud rate. Default setup is 9600.
Default setup is 8. Please set according to the speed dome dial switch
setup.
Default setup is 1. Please set according to the speed dome dial switch
setup.
Default setup is none. Please set according to the speed dome dial
switch setup.
5.9.6 Information
5.9.6.1 Version
The version interface is shown as in Figure 5-56.
Here you can view system hardware features, software version, release date and etc. Please note
the following information is for reference only.
Figure 5-56
5.9.6.2 Log
Here you can view system log. See Figure 5-57.
To Next Page
Loading...
Need help?
General