Local Configurations 101
Figure 5-60
In the Patrol No. box, enter the value for the tour route. Step 3
In the Preset box, enter the preset value. Step 4
Click Add Preset. Step 5
A preset will be added for this tour.
You can repeat adding more presets.
Click Del Preset to delete the preset for this tour. This operation can be repeated
to delete more presets. Some protocols do not support deleting.
5.4.3.3 Configuring Patterns
On the Expanded PTZ Control Panel, click . Step 1
The PTZ interface is displayed.
Click the Pattern tab. Step 2
The Pattern interface is displayed. See Figure 5-61.
Figure 5-61
In the Pattern box, enter the value for pattern. Step 3
Click Start to perform the directions operations. You can also go to the PTZ Control Step 4
Panel to perform the operations of adjusting zoom, focus, iris, and directions.
On the PTZ interface, click End to complete the settings. Step 5
To Next Page
Loading...
Need help?
General