Local Configurations 237
Displays the network type. Different type represents different supplier.
Displays the default APN number.
Displays the default dial No.
Authentication mode. You can select PAP, CHAP, or NO_AUTH.
Table 5-61
Select the Enable check box. Step 4
Click Dial to start connecting. Step 5
After the connection is established, the result is displayed in the Wireless Network
area. See Figure 5-201.
Figure 5-201
Click Apply to complete the settings. Step 6
Supported 3G/4G Modules by the Device
China Mobile 3G/4G: ZTE MF832S
China Mobile 4G: ZTE MF832S
China Unicom 3G: ZTE MF667S, HUAWEI E353U-1
China Telecom 4G: HUAWEI EC122, ZTE AC2736
If the Device is connected to China Telecom 3G/4G network, you can login the Device with
the public IP address through the PC of public internet (The HTTP port is not configured as
80). If the Device is connected to China Unicom or China Mobile 3G network, which are
defined as private network, therefore you cannot login the Device through PC that is
connected to public internet.
To Next Page
Loading...
Need help?
General