User’s Manual
57
Step 1 Select Setup > Network > IEEE802.
Figure 4-60 IEEE802
Step 2 Select the Enable check box to enable IEEE802, and then configure the parameters.
Table 4-30 IEEE802 parameters description
Authentication
PEAP: Ordinarily uses TLS only to authenticate the server to the client, and
only the sever is required to have a public key certificate.
EAP-TLS: Provides mutual authentication of client to server and server to
client. Both the client and the server must be assigned a digital certificate
signed by a CA (Certificate Authority) that they both trust.
CA Certicate
Select the CA Certificate check box, and then click Browse to import the
CA Certificate to verify whether the switch is valid.
PEAP
Username
For PEAP method, user authentication is performed by using
password-based credentials (username and password).
EAP-TLS
Client
Certificate
Click Browse to import the client certificate and private key files for
authentication.
Private Key
Step 3 Click Confirm.
4.5.3.5 ITC Push
You can configure this parameter to push the captured vehicle violations information to the
server.
Step 1 Select Setup > Network > ITCPUSH.
To Next Page
Loading...
Need help?
General
