User’s Manual
56
Figure 4-59 SMTP (email)
Step 2 Configure the parameters as needed.
Table 4-29 SMTP (Email) parameter description
SMTP Server IP address of the outgoing mail server that complies with SMTP protocol.
Port
Port number of the outgoing mail server complying with SMTP protocol.
It is 25 by default.
Username Username of sender mailbox.
Password Password of sender mailbox.
Anonymity
For servers supporting anonymous email, you can log in anonymously
without entering username, password, and sender information.
Sender Email address of the sender.
Encryption Type
Select encryption type from
,
and
.
Title
You can enter no more than 63 characters in English letters and
Email address of the receiver. Supports 3 addresses at most.
Select the check box to support attachment in the email.
Interval The interval of sending emails.
Health Mail
The system sends test mail to check whether the connection succeeds.
Select the Health Mail check box, and configure the Update Period, and
then the system sends test mails according to the defined period.
Tes t
Test whether the email function is normal. If the configuration is correct,
the email address of the receiver will receive the test email. Save the
email configuration before running rest.
Step 3 Click Save.
4.5.3.4 IEEE802
The IEEE802 standard helps authenticate and secure network by providing authentication for
devices trying to connect with other devices on LANs or WANs. You can configure the
parameters of the standard to make it work.
To Next Page
Loading...
Need help?
General
