User’s Manual
59
Step 1 Select Setup > Event > Alarm > Relay Activation.
Figure 4-62 Relay activation
Step 2 Select the Enable check box to enable alarm input for the current channel.
Step 3 Set the period of alarm input.
1) Click Setup.
Figure 4-63 Period
2) Click Setup corresponding to the day you need to configure time period.
3) Select the period you need to enable and enter start time and end time of
corresponding period.
4) If you need to apply this period setting to any other day, select the check box of the
corresponding days.
5) Click Confirm to save the settings.
You can repeat these steps to apply the Settings to other days.
Step 4 Set other parameters.
To Next Page
Loading...
Need help?
General
