User’s Manual
65
Figure 4-75 FTP
Step 2 Configure the parameters.
Table 4-34 FTP parameter
Offline Transfer
When the network disconnects or fails, snapshots will be stored in TF card.
After the network is restored, the snapshots will be uploaded from the TF
card to FTP or client.
Make sure that TF card is inserted in the Camera; otherwise, the offline
transfer function cannot be enabled.
FTP Named
Set the naming rule of snapshots to be saved in FTP server. You can click
Help… to view the Picture Naming Help, or click Restore to restore the
Enable Enable FTP server storage.
Protocol
SFTP (Recommended): Secure File Transfer Protocol, a network protocol
allows file access and transfer over a secure data stream.
FTP: File Transfer Protocol, a network protocol implemented to exchange
files over a TCP/IP network. Anonymous user access is also available
through an FTP server.
The IP address of FTP server.
Encode Mode
Refers to the encode mode of Chinese characters when naming pictures.
Two modes are available: UTF-8 and GB2312. After configuring Server IP
and
, click
to check whether the FTP server works.
The port number of FTP server.
Username,
The username and password of FTP server.
Select event(s) and picture type(s) to be uploaded to the FTP server.
Step 3 Click Confirm.
To Next Page
Loading...
Need help?
General
