User’s Manual
66
4.5.5.4 Client
You can set the parameters of storing to client.
Step 1 Select Setup > Storage > Destination > Client.
Figure 4-76 Client
Step 2 Configure parameters.
Table 4-35 Client
Offline
Transfer
When network is disconnected or failed, you can store the picture into local
storage card and it will automatically upload to platform server after network
resumes.
When checking Offline Transfer, Manual Upload option will be displayed.
Then you can configure Begin Time and End Time, and choose the server to
Type
Select connection type with platform server.
IP: Connect to platform server through IP address.
MAC: Connect to platform service through MAC address.
Select server which includes Server1 and Server2.
Server IP
When the type is selected as IP, then it has to fill in the server’s IP address.
When the type is selected as MAC, then it has to fill in the server’s MAC
address.
Step 3 Click Confirm.
4.5.5.5 Path
This section provides guidance on configuring picture, record naming, and storage path.
Step 1 Select Setup > Storage > Destination > Save Path.
To Next Page
Loading...
Need help?
General
