Set the image sharpness under the scene.
The bigger the value is, the higher the detail contrast becomes, the clearer
the image becomes. The image tends to generate noise when the value is
set too big.
The system dims bright areas and compensates dark areas to ensure the
clarity of both areas. The bigger the value is, the higher the WDR level
becomes.
Select lens exposure mode, which includes auto and manual.
Manual: Fixed exposure value. It needs to set the time of manual
exposure, including 8 options between 1/50 and 1/10000.
Users can customize value and range.
Auto Gain: Set the range of auto gain.
Fixed Gain: Set the fixed gain value.
Select the device environment and set scene mode. Adjust the device
monitoring image to its best status.
Click OK to finish configuration.
5.4.2.1.3 Metering Zone
In this section, you can set the measure mode of metering zone.
Select Setting > Camera > Attributes > Metering Zone.
The Metering Zone interface is displayed, see Figure 5-45.
Metering Zone
Configure parameters according to actual requirement. Please refer to Table 5-22 for
more details.
To Next Page
Loading...
