Local Basic Operations 200
Define for several days of a week: Click before each day, the icon
switches to . On the timeline of any selected day, click the half-hour blocks
to select the active periods, all the days with will take the same settings.
Define for all days of a week: Click All, all switches to . On the
timeline of any day, click the half-hour blocks to select the active periods, all the
days will take the same settings.
Define the period by editing. Take Sunday as an example.
1) Click .
The Period interface is displayed. See Figure 4-176.
Figure 4-176
2) Enter the time frame for the period, and then select the check box to enable the
settings.
There are six periods for you to set for each day.
Under Copy, select All to apply the settings to all the days of a week, or select
specific day(s) that you want to apply the settings to.
3) Click OK to save the settings.
Step 3 On the Motion Detect interface, click Apply to complete the settings.
4.8.5.2 Tampering
When the camera lens is covered, or the video is displayed in a single color because of sunlight
status, the monitoring cannot be continued normally. To avoid such situations, you can configure
the tampering alarm settings.
Step 1 Select Main Menu > ALARM > VIDIEO DETECTION > Tampering.
The Tampering interface is displayed. See Figure 4-177.
To Next Page
Loading...
Need help?
General