Local Basic Operations 50
In the IP Version list, you can select IPv4 or IPv6. Both versions are
supported for access.
Displays the MAC address of the Device.
Enable the DHCP function. The IP address, subnet mask and default
gateway are not available for configuration once DHCP is enabled.
If DHCP is effective, the obtained information will display in the IP
Address box, Subnet Mask box and Default Gateway box. If not,
all values show 0.0.0.0.
If you want manually configure the IP information, disable the
DHCP function first.
If PPPoE connection is successful, the IP address, subnet mask,
default gateway, and DHCP are not available for configuration.
Enter the IP address and configure the corresponding subnet mask and
default gateway.
IP address and default gateway must be in the same network segment.
Enable the DHCP function to get the DNS address from router.
In the Preferred DNS box, enter the IP address of DNS.
In the Alternate DNS box, enter the IP address of alternate DNS.
In the MTU box, enter a value for network card. The value ranges from
1280 byte through 1500 byte. The default is 1500.
Click Test to test if the entered IP address and gateway are
interworking.
Step 4 Click OK to NIC settings.
Device goes back to TCP/IP interface.
Step 5 Set network parameters. See Table 4-6.
Table 4-6
There are two options: IPv4 and IPv6. Right now, system supports
these two IP address format and you can access via them.
DNS server alternate address.
Displays the MAC address of the Device.
Enable the DHCP function. The IP address, subnet mask and default
gateway are not available for configuration once DHCP is enabled.
If DHCP is effective, the obtained information will display in the IP
Address box, Subnet Mask box and Default Gateway box. If not,
all values show 0.0.0.0.
If you want manually configure the IP information, disable the
DHCP function first.
To Next Page
Loading...
Need help?
General