Page.5.
AHD camera image display, 4Xzoom, video record and playback, Coaxial PTZ control and call
HDMI signal output, supports up to 1080P.
Analog camera image display, auto adapt and display the video format of NTSC/PAL
Support more than 30 protocols, such as PELCO-P,PELCO-D,SAMSUNG etc
Video image digital zoom to view the image in greater detail.
Snapshot function allows you to save the current image as a JPG file in the tester.
Built in enhanced color bar generator, send the color, pure blue and black image, test monitor
transmission channel and debug display device, observe whether there are light spots or black
spots on the monitor.
LCD screen brightness/contrast/color Saturation adjustable.
Visual fault locator, to test fiber’s bending and breakage
Optical power meter, test fiber loss and value
Digital Multi-meter , DC and AC voltage measurement, Resistance measurement Continuity test,
Diode measurements, Capacitance measurement
PEAK video signal level, SYNC signal level, Color burst chroma level measurement,test video
signal attenuation.
Cable tracer, by sending the audio signal, enables the blue cable tracer tester to find the
connected cable from mess cables.
Ping test, PING is the most conventional network debugging tools, it is used for testing if the
connected IP camera or other network equipment’s Ethernet port is working normally and the IP
address is correct.
In digital IP surveillance applications, if the IP camera’s IP address is not known,the device
cannot be used. An IP address scan can quickly search for the connected IP camera or other
network device’s IP address.
The PoE voltage test can test for PoE voltage when a POE switch is supplying POE power to an
IP camera.
TDR cable test, test cable open circuit and short-circuit
To Next Page
Loading...
Need help?
General