Page.80.
Note:
1. Don’t input power into the “DC12/2A OUTPUT” port.
2. Don’t output this DC12V/2A power to the DC12V/IN port of the Integrated Mount Tester to avoid
destroy.
3. The Integrated Mount Tester power output is close to 2A, if the IP camera’s power is over 2V, the
tester will auto enter protection mode. Disconnect all the connections of the tester and then connect
the tester with power adaptor to resume the tester.
4. Before turning on the PoE power output, please make sure the IP camera supports PoE power.
Otherwise it may damage the IP camera.
5 Make sure you plug in your IP camera to the LAN port prior to turning on PoE power.
6. Make sure the tester is full charged or more than 80% charged, otherwise the tester will shows
“low power”, “not able to supply power”.
Click icon to enter
To Next Page
Loading...