Page.82.
Single test: test cable status, length and attenuation.
Repeat test: continue to test cable status, length and attenuation.
Status: after link up, screen display “online”, if not link up or open circuit, screen display ”open
circuit”, if cable pair is short circuit, screen display “short circuit”.
Length: the max test length is 180 meters, when cable is open circuit or short circuit, can test the cable
length, if screen display “online”, the testing result would be not accurate.
Cable quality test: Green is good quality cable, Yellow is Poor quality cable, Red is water poured
cable, the attenuation value will be displayed when cable over 10 meters
Advanced Test: test cable pair status, length, attenuation, reflectivity, impedance, skew and other
parameters.
Attenuation reflectivity: after link up, if reflectivity value is 0, it is the best quality communication
Impedance: after link up ,if the impedance value is 100Ω,it is the best quality communication, the
To Next Page
Loading...
Need help?
General