Daikin SkyAir FHQ24PVJU - Page 178

Field Settings from Outdoor Unit SiUS281811EA
172 Part 5 Field Settings and Test Operation
Procedure for changing COOL/HEAT selection setting
Press the SET (BS2) button to set
the blinking LED according to the
pattern shown on the right.
Press the RETURN (BS3) button to
determine the setting.
Check the system for each condition
through LED displays. (Refer to
information in table on the right.)
Press the RETURN (BS3) button and
return to the initial status of setting
mode 1.
h
h
h
h
h
h
l
h
h
h
l
h
h
h
l
h
h
h
h
h
h
k ON
h OFF
l Blink
Procedure for checking
Setting mode 1 is the initial status
(normal). In case of other status,
press the MODE (BS1) button one
time and return to the setting mode 1.
MODE
H1P
TEST
H2P
COOL/HEAT select
IND
H3P
MASTER
H4P
SLAVE
H5P
Low
noise
H6P
Demand
H7P
hhkhhhh
Setting (displaying) item
MODE
H1P
TEST
H2P
COOL/HEAT select
IND
H3P
MASTER
H4P
SLAVE
H5P
LOW
NOISE
H6P
DEMAND
H7P
For selection by individual outdoor
unit (factory setting)
For selection in a batch of outdoor
unit group with master unit
For selection in a batch of outdoor
unit group with slave unit
The system returns to the initial status of setting mode 1.
Current operating conditions
h Normal
k Abnormal
l In preparation or in
check operation
Setting of COOL/HEAT selection
khhBy individual outdoor
unit
hkhIn a batch of outdoor unit
group with master unit
hhkIn a batch of outdoor unit
group with slave unit
Low noise operating conditions
h In normal operation
k In low noise operation
Demand operating conditions
h In normal operation
k In demand operation
Setting mode 1 is the initial status
(normal). In case of other status,
press the MODE (BS1) button one
time and return to the setting mode 1.