Daikin SkyAir FHQ24PVJU - Simplified Remote Controller

SiUS281811EA Names and Functions
Part 3 Remote Controller 87
2.2 Simplified Remote Controller
F
BRC2A71
H L
3
13
5
10
6
1
4
9
2
7
8
11
12
1
2
3
4
5
6
It is impossible to changeover heating/cooling with the
remote controller when it shows this display. (As for
details, see “SETTING OF MASTER REMOTE
CONTROLLER” in the installation manual attached to
the indoor unit.)
Indicates that defrost or hot start (during which the fan
is stopped until the temperature of air supply rises
enough at the start of a heating operation) is in
progress.
This display shows that the total heat exchanger and
the air cleaning unit are in operation. (These are
optional accessories).
DISPLAY “ ” (VENTILATION/AIR CLEANING)
This display shows current OPERATION MODE.
“ ” is not available with outdoor units specially
designed for cooling only.
“ ” is reserved only for outdoor units capable of heat
recovery.
OPERATION LAMP (RED)
ON/OFF BUTTON
Press the button and the system will start. Press the
button again and the system will stop.
The lamp lights up during operation. Blinks in case of
stop due to malfunction.
This display shows the set temperature. Only given
during a cooling or heating operation.
DISPLAY “ ” (SET TEMPERATURE)
DISPLAY “ ” “ ” “ ” “ ” “ ”
(OPERATION MODE)
7
8
13
11
Indicates malfunction and blinks if the unit stops
operating due to malfunction.
(As for details, see “TROUBLE SHOOTING” in the
operation manual attached to the outdoor unit.)
10
When this display shows, the system is UNDER
CENTRALIZED CONTROL.
(This is not a standard specification)
This display shows the fan speed: HIGH or LOW.
9
Press this button to select the fan speed, HIGH or LOW,
of your choice.
12
Press this button to select OPERATION MODE.
DISPLAY “ ” (DEFROST / HOT START)
DISPLAY “ ” (UNDER CENTRALIZED
CONTROL)
DISPLAY “ ” (MALFUNCTION)
FAN SPEED CONTROL BUTTON
OPERATION MODE SELECTOR BUTTON
TEMPERATURE SETTING BUTTON
DISPLAY “ ” (FAN SPEED)
HL
DISPLAY “ ” (CHANGEOVER UNDER
CONTROL)
Use this button for SETTING TEMPERATURE of the
thermostat.
; Each press raises the set temperature by 1°F.
; Each press lowers the set temperature by 1°F.
The v
90°F.
ariable temperature range is between 60°F and