Daikin SkyAir FHQ24PVJU - Page 213

SiUS281811EA Troubleshooting with Remote Controller
Part 6 Service Diagnosis 207
 The lower digit of the code changes as shown below.
Continuous beep : Both upper and lower digits match. (Error code is confirmed.)
2 short beeps : The upper digit matches but the lower digit does not.
1 short beep : The upper digit does not match.
7. Press MODE button to return to the normal mode. If you do not press any button for 1 minute,
the remote controller automatically returns to the normal mode.
0
1
2
3
4
5
6
7
8
9
A
H
C
J
E
F
"UP" button "DOWN" button
If no button is pressed
for 1 minute, equipment
returns to normal mode.
3. Press MODE
button.
The upper digit
blinks.
Normal mode
1. Press INSPECTION/TEST button to enter
inspection mode.
7. When MODE button is
pressed or no button is
pressed for 1 minute,
equipment returns to
normal mode.
6. Change the lower
digit with UP
button or DOWN
button.
If no button is pressed
for 1 minute, equipment
returns to normal mode.
5. Press MODE button.
The lower digit blinks.
4. Change the
upper digit with
UP button or
DOWN button.
2. Change the unit num
ber with
UP button or DOWN button.