Daktronics RC-200 User Manual

Introduction
1
1 Introduction
This manual is designed to explain the operation of the Daktronics RC-200 Remote
Control System for All Sport
®
applications. For additional information regarding the safety,
installation, operation, or service of this system, refer to the telephone numbers listed in
Daktronics Exchange and Repair & Return Programs (p�2).
Important Safeguards
• Read and understand all instructions, both general and for specic applications.
• Always turn off and/or unplug the control equipment when it is not in use� Never yank
the power cord to pull the plug from the outlet� Grasp the plug and pull to disconnect�
• Do not drop the control console or allow it to get wet�
• Do not disassemble control equipment or electronic controls of the display; failure to
follow this safeguard will make the warranty null and void�
• Do not let any power cord touch hot surfaces or hang over the edge of a table that
would damage or cut the cord�
• If an extension cord is necessary, use a three-pronged, polarized cord� Arrange the
cord with care so that it will not be tripped over or pulled out�
• Inspect console for shipping damage such as rattles and dents, and verify that all
equipment is included as itemized on the packing slip� Immediately report any
problems to Daktronics; save all packing materials if exchange is necessary�
• Use only the 18 VDC wallpack charger or charging station provided from Daktronics
for recharging the battery� Refer to Battery Recharging (p�5)�
CAUTION! RISK OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED�
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS�
Specications Label
Power specications as well as product assembly
information can be found on an ID label on the back
of the handheld device and on the bottom of the
base station, similar to those shown in Figure 1.
When calling Daktronics customer service,
please have the assembly number and the date
manufactured available to ensure the request is
serviced as quickly as possible.
Recommended Temperatures
• Operation: 14° to 149° Fahrenheit (-10° to 65° Celsius)
• Charging: 32° to 104° Fahrenheit (0° to 40° Celsius)
• Storage: -4° to 113° Fahrenheit (-20° to 45° Celsius)
Resources
Figure 2 illustrates a Daktronics drawing label. This
manual refers to drawings by listing the last set of digits.
In the example, the drawing would be referred to as
DWG-1007804. All references to drawing numbers,
appendices, gures, or other manuals are presented in
bold typeface.
ASSY NO.
SER. NO.
MFG DATE
BROOKINGS, SD 57006-5128
PHONE 800-325-8766
LL-2305 R01
201 DAKTRONICS DR.
DAKTRONICS
Wireless Handheld:
Wireless Base Station:
ASSY NO.
SER. NO.
MFG DATE
BROOKINGS, SD 57006-5128
PHONE 800-325-8766
LL-2305 R01
201 DAKTRONICS DR.
DAKTRONICS
0A-1110-0062
S/N: ####
(DATE) REV ##
POWER: 18V , 1.1A
MODEL: DAKT-0406-00
0A-1110-0067
S/N: ####
(DATE) REV ##
POWER: 12-18V , 0.1A
MODEL: DAKT-0406-00
Figure 1: Specications Labels
Drawing Number
Figure 2: Drawing Label

Daktronics RC-200 Specifications

General

Brand	Daktronics
Model	RC-200
Category	Remote Control
Language	English