EasyManua.ls Logo

Daktronics RC-200 - Troubleshooting and Appendices; Error Messages and Troubleshooting

Daktronics RC-200
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting
36
17 Troubleshooting
Handheld Controller Error Messages
Display Cause/Solution
NO SERVER FOUND
B: XX C: YY
XX = Broadcast Group #
YY = Channel #
ENT TO RETRY
CLEAR SETS CHAN
The wireless handheld could not nd a server on the specied
broadcast group and channel.
Make sure the wireless Base Station is powered on, and is set
for the specied broadcast group and channel.
Make sure the handheld is within minimum and maximum
range limits. Refer to RC-200 System Overview (p�4).
Press <ENTER> to retry the connection (if the handheld was
just moved in range or the wireless Base Station has been
correctly congured).
Press <CLEAR> to set the broadcast group and channel to a
different number and retry.
NO RESPONSE ON
B: XX C: YY
XX = Broadcast Group #
YY = Channel #
ENT TO RETRY
CLEAR SETS CHAN
The wireless handheld did nd a server on the specied
broadcast group and channel, but the server did not respond.
Make sure the handheld is within minimum and maximum
range limits. Refer to RC-200 System Overview (p�4).
Cycle power to the wireless Base Station and retry the
connection.
Make sure that there are no other wireless Base Stations
within range on the same group or channel. Try a different
group/channel if necessary.
Press <ENTER> to retry the connection (if the handheld was
just moved in range or the wireless Base Station has been
correctly congured).
Press <CLEAR> to set the group/channel to a different
number and retry.
ERROR - THIS
CHANNEL IN USE
The message at left is displayed if another wireless handheld
controller is currently connected to the Base Station and the
application does not permit multiple handheld units.
Power off any other unused handheld units on the same
channel in the area. Refer to Powering the Controller On & Off
(p�5).
Although multiple wireless handheld controllers may be
connected to a single Base Station, the following applications
only allow one handheld device to be connected at a time:
• Baseball • Play Clock/Pitch Timer
• Basketball • Remote Start/Stop
• Clock/Score • Segment Timer
• Football • Volleyball
• Goal Judge

Table of Contents