EasyManua.ls Logo

Daktronics RC-200 - 11 Sand Volleyball Operation; Court Selection; Serve; Point

Daktronics RC-200
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Sand Volleyball Operation
27
11 Sand Volleyball Operation
Sport Insert: LL-2607
Code: 09
The sport insert drawing is located in Appendix B. If an insert is lost or damaged, a copy
of the insert drawing can be used until a replacement arrives. Refer to Powering the
Controller On & Off (p�5) for information on starting the console and Common All Sport
Application Keys (p�12) for additional All Sport application keys.
Court Selection
Multiple wireless handheld controllers may be connected to a single wireless Base Station
in the Sand Volleyball application. Each connected handheld controller will operate a
specic court, and the controller number for the handheld is selected when powered up.
Display Action
ENTER CONTROLLER
NUMBER NN*
NN = current setting
Enter the controller number for the court that this particular
handheld will operate and then press <ENTER>.
Typically, controller 1 would run court 1, controller 2 would run
court 2, and so on. Some systems may be set up differently.
ERROR - NUMBER
TAKEN
ERROR - INVALID
NUMBER
If the number entered has already been selected for
another controller, the error message at top left will display.
Select another number.
If the controller number entered is too high, the error
message at bottom left will display. Select another number.
Note: On the sport insert and LCD, “TOP” = HOME and “BOT” = GUEST.
Serve
Display Action
TOP SERVE
ON
TOP SERVE
OFF
Press the Top/Bottom <SERVE> key to turn the serve indicators
ON or OFF for the respective team.
Note: When one serve indicator is already on, pressing the
opposite <SERVE> key will turn it off.
Point
Press the Top/Bottom <POINT> key to increment the total points by 1 for the respective
team in the currently selected set. The new point values appear immediately on the LCD.
Display Action
SCORE EDIT
TOP NN*
NN = current setting
Press <EDIT> followed by the Top/Bottom <POINT> key to display
the current setting. Enter the correct value using the number
keys, and then press <ENTER>.

Table of Contents