Segment Timer Operation
23
Auto Stop
Note: To set the console to stop after the last segment in the series is completed, the
auto stop at each segment setting must be set to NO.
Display Action
STOP AT EACH SEG
1-YES 2*NO
* = current setting
Press <AUTO STOP> to enter this menu.
• Press <1> to set the console to stop after each segment is
completed.
• Press <2> to set the console to automatically begin the next
segment when each segment is completed.
STOP AT LAST SEG
1*YES 2-NO
* = current setting
If Stop at Each Segment is set to NO, the console will prompt for
the Auto Stop at Last Segment setting:
• Press <1> to set the console to stop when the last segment
has been completed.
• Press <2> to set the console to start over at the rst segment
when the last segment is completed.
Warning Time
Display Action
WARNING TIME
MM:SS*
MM:SS = minutes, seconds
When the warning time is reached, the segment number ashes
until the main clock reaches zero.
Press <WARNING TIME •>, enter the time in minutes and seconds
using the number keys, and then press <ENTER>.
Enter 00:00 for no warning time (default).
To Next Page
Loading...