Daktronics RC-200 - 9 Segment Timer Operation; Segment Timer Information; Segment Number;Time; First;Last Segment

Segment Timer Operation
21
9 Segment Timer Operation
Sport Insert: LL-2613
Code: 06
The sport insert drawing is located in Appendix B. If an insert is lost or damaged, a copy
of the insert drawing can be used until a replacement arrives. Refer to Powering the
Controller On & Off (p�5) for information on starting the console and Common All Sport
Application Keys (p�12) for additional All Sport application keys.
Segment Timer Information
The segment timer is used to time events such as practice sessions. Operation of the
segment timer is determined by 40 segments of pre-programmed length. The segment
timer will count down starting at the segment number that is set as First Segment. When
the rst segment is completed, the timer will count the preset Interval Time and move on
to the next segment. The timer will continue counting segments until the segment number
that is set as Last Segment is complete. It then will reset to the segment saved as the First
Segment and will either begin counting down or wait for the <START> key to be pressed,
depending on the Auto Stop At Last Seg setting. Refer to Auto Stop (p�23) to set the
segment-stopping feature.
The First Segment and Last Segment values can be used to set up specic practice
sessions. For example, the practice session for one sport could be programmed for
5-minute segments on segments 1–10, while another might use 10-minute segments on
segments 11–20. Set the First Segment and Last Segment values to the desired segment
numbers for the session, and the console will count down each of the segments in order.
It may also be set to either stop on the last segment or loop back to the rst segment
segments, again based on the Auto Stop At Last Seg setting.
Segment Number/Time
Display Action
SEGMENT: NN
TIME EDIT MM:SS*
SEGMENT: NN*
TIME EDIT
NN = segment number
MM:SS = minutes, seconds
Press <SEG� NO� • TIME •> to set individual segment times.
Enter the segment to be edited using the number keys, and
then press <ENTER>.
Enter the time for the segment using the number keys.
Press <ENTER> to move to the next segment time.
Press <ENTER> again to exit the function.
First/Last Segment
Display Action
FIRST SEG NN*
LAST SEG XX
NN = current rst segment
XX = current last segment
Press <FIRST/LAST SEGMENT>, use the number keys to enter the
segment to be set as the rst segment, and then press <ENTER>.
Use the number keys to enter the segment to be set as the last
segment, and then press <ENTER>.
The console will be reset to the segment selected here when the
<RESET TO FIRST SEGMENT> key is pressed. After the segment set
as the last segment is completed, the console will automatically
reset to the segment saved as the rst segment.