Daktronics RC-200 - Current Segment +1; Reset Current Segment; Reset to First Segment; Interval Time

Segment Timer Operation
22
Current Segment +1
Press <CURRENT SEGMENT +1> to move to the next segment. The new segment number
appears immediately on the LCD.
Display Action
CURRENT SEGMENT:
EDIT NN*
NN = current setting
Press <EDIT> followed by <CURRENT SEGMENT +1> to display the
current setting. Enter the correct value using the number keys,
and then press <ENTER>.
Reset Current Segment
Press <RESET CURRENT SEGMENT> to reset the segment time to the value specied by the
current segment. The segment number will remain at the current value.
Reset to First Segment
Press <RESET TO FIRST SEGMENT> to return to the rst segment.
Note: This function is disabled while the clock is running.
Interval Time
The interval time is the time between each segment.
Display Action
INTERVAL TIME:
MM:SS*
MM:SS = minutes, seconds
Press <INTERVAL TIME •> to display the current value of interval
time. Enter the interval time using the number keys, and then
press <ENTER>.
DISPLAY INTERVAL
1-YES 2*NO
* = current setting
This setting determines whether the interval count will be
displayed on the scoreboard.
Press <1> to display the interval time on the scoreboard.
Press <2> to disable interval time display. The interval time will be
displayed only on the controller.
Note: Regardless of this setting, the value saved in interval time
will be counted down between segments. Set the interval
time to 00:00 if no interval between segments is desired.
Note: When the interval time is being displayed, the segment
number on the scoreboard ashes to indicate that the
time displayed is interval time.
Copy Range
This key sets a range of segments to a specic time value.
Display Action
COPY: MM:SS *
SEG XX TO YY
MM:SS = minutes, seconds
XX = starting segment value
YY = ending segment value
Press <COPY RANGE •> and enter the time desired. Press
<ENTER> to move to the next eld. Enter the rst and last
segments that will have this time. When the last segment in the
copy range is set, the menu will exit.
Once completed, all segments from XX to YY (inclusive) will be
set to the specied time.